![]() If it helps, I can make a quick video for you to reference. I have since noticed that my original one doesn’t have a mark on the top, like the other two, so I now can do this easy. ![]() I ran into this when I mistakenly connected a single flare 2 to my iPad, when I hadn’t realized it wasn’t the same one as the last I did. They should see each other, and only one to your device, and should work as intended (and through the app now). Then press and hold the Bluetooth button on the first speaker so it flashes white and then release. Turn back on the second flare 2, and press and hold the BT button until it flashes white, then release. If the speaker is already connected to a device but still keeps turning off, it means it has a low battery. If you find they are both connected, I’d then offer, to forget one of the on your device, turn off that speaker, at this point you should have just the one connected and the BT icon should be solid blue. The reason your Anker Soundcore 2 speaker keeps turning off is because you haven’t connected it to any device for around 10 minutes. If so, that would explain why they flash same color. Perhaps one is connected to another device… should only have one connected to your main device, and the other connected to nothing when you start out. We will reply you within 24 hours.I think I may have something to help… on your device and see if both of your flare 2s show as connected to your device. If the monitor keeps disconnecting and reconnecting or flashing through the. If the issue still persists, don’t worry, please don’t hesitate to contact us at by detailing your order number and the problem you come across. this requires to re do the setup of the device.6ft. Turn back on the Bluetooth on your device and find the Soundcore to pair them.The LED indicators will flash red 3 times and then turn white. The first troubleshooting step you should do is a factory reset or hard reset. Press and hold the button on both earbuds for 3 seconds. Method 1: Perform a factory reset on Anker SoundCore.Place the earbuds into the charging case and make sure they are being charged with a steady light on the earbuds.Forge the pairing record on your device and reset the earbuds per the steps below: Fully charge and reset your earbuds as stated below and pair them again: - Place the earbuds into the charging case and keep the case open.It connects to your audio device and to the left earbud. Your right Soundcore earbud is the master (main) earbud. Reboot your Soundcore Motion Boom Plus speaker and your phone. Forget all Bluetooth pairing records on your phone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |